Furnace Igniter & Flame Sensor Repair in Lancaster, OH
Modern gas furnaces use either a silicon nitride/silicon carbide hot surface igniter or an intermittent spark igniter paired with a flame sensor rod. After thousands of heating cycles through Fairfield County winters—especially in older homes around Square 13 and Rising Park—igniters grow brittle and flame sensors coat with carbon.
What This Service Covers
- Hot surface igniter resistance (ohms) testing and OEM replacement
- Flame sensor micro-amp testing, cleaning, or rod replacement
- Spark igniter module and pilot assembly troubleshooting
- Control board lockout code clearing and full ignition cycle verification
Common Warning Signs
- Draft inducer motor runs, igniter clicks, but burners never light
- Burners ignite for 3–5 seconds and immediately shut back off
- Furnace enters soft lockout after three failed ignition attempts
- Blinking diagnostic LED code on the furnace control board
Cost Factors in Lancaster, OH
Flame sensor service ($150–$250) and hot surface igniter replacement ($150–$500) are among the most affordable furnace repairs. Catching a failing igniter early prevents repeated cold-weather lockouts requiring emergency dispatch. Check our Lancaster homepage for full service options.
Frequently Asked Questions
Most hot surface igniters last 3 to 7 years depending on heating runtime and power quality. Silicon nitride igniters generally outlast older silicon carbide models.
Yes. If the flame sensor cannot detect micro-amp current from the burner flame, the safety control board shuts the gas valve off within seconds to prevent unburned gas buildup.